0
0
Having an RV makes you ready to take any adventure on the wheels. It gives you freedom and excitement of the new places. However, many times, the RV takes us to places that have some extreme weather conditions.Â
And the need for RV covers become more relevant. Moreover, for the protection of your vehicle covers are required. It protects your vehicle – UV rays, moisture, and even from nature.Â
However, after getting your vehicle covered, some issues need attention. But what are you facing and the possible solutions? For that read the below piece and get the answers to your questions.Â
Some Issues And Solutions
-
Covers Have Poor Fit
Problem –
Are you among those who are struggling with the RV cover proper installation? If, yes, then have you noticed the problem you’re facing?Â
The problem could be –Â
- if it’s too loose, the cover flaps in the wind causing abrasion on the RV’s surface.Â
- On the other hand, if the cover is tied too tight, it could lead to difficult installing and tearing.
Solution –
Ok. To have the RV Covers, that ultimately give you the perfect fit. Take measurements of the RV – length, width, and height, and compare these with the covers’ specifications.
- If the cover is loose, then use the additional straps or bungee cords to secure it.Â
- For tight covers – invest in the larger sizes or go with the model that has the adjustable features – elastic hems, or adjustable straps. This ensures a snug fit but not an overly tight fit.
-
Water on the Covers
The Issue –
During heavy rains, there comes the problem of water pooling on the RV covers for travel trailers. If not cleaned properly, the water can seep through the cover on the vessel. This causes moisture to the RV, which results in mold growth.
Let’s Fix it –
Preventing water pooling is the ultimate solution. So, ensure that your RV’s cover is properly pitched so that water can run off rather than collect on the surface. Some RV covers come with built-in vents to help water drain.Â
If yours doesn’t, you can create a makeshift pitch by placing foam blocks or beach balls under the cover in the right spots. This creates a slope that encourages water to run off rather than pooling on top.
-
There are Tears and Holes
What’s the Fix –
You notice some tears and holes in your RV covers, what could be the possible reason? These are some of the reasons -sharp edges on the RV, exposure to harsh weather, or carelessness. When you see these openings reduce the cover’s effectiveness, allowing dirt, debris, and moisture to reach your RV.Â
The Solution –
Check your RV cover for any damage. In case you see small spots of tear, fix these immediately. But how? With a patch kit made for fabric or vinyl covers.Â
Or just clean the area. Apply the patch as the instruction says. After that let it dry completely before putting the cover back on. For bigger tears or if the cover is worn out, it might be better to just replace it, especially if it’s getting old.
-
Damage From The Wind
What’s Your Problem –
Are you an adventure enthusiast who takes an RV Or do you have to travel in extreme conditions? Strong winds can make your RV cover flap around. This can scratch the RV’s surface and even tear the cover. The result – shorten the cover’s life and might also damage your RV’s paint and finish.
Solution –
To avoid wind damage, make sure your RV cover is tightly secured. Use all the straps and tie-downs that come with it, and think about adding extra bungee cords or rope for extra security.Â
If you often park your RV in a windy spot, you might want a cover made for high-wind conditions. It will usually have reinforced straps and tougher materials. If you can, try to park your RV in a more sheltered place to lessen the wind’s impact on the cover.
-
Growing of Mold and Mildew
Your Problem –
If your RV is stored while still damp or if the cover doesn’t breathe properly, there is a higher chance mold and mildew develop. This can damage the cover and might even spread to your RV, causing bad smells and possible health issues.
The Solution –
To prevent mold and mildew, always ensure that your RV cover is completely dry before storing it. If your cover becomes wet during use, allow it to dry out before folding it up.Â
Additionally, look for covers made from breathable materials that allow moisture to escape while still protecting your RV from the elements. Regularly cleaning the cover with a mild detergent and water can also help prevent mold and mildew growth.
The Solved Problems
These are some of the problems which are faced by everyone having an RV. By using the referred solutions, you’ll have peace of mind. Moreover, if you need more safety for your bank balance also, then get the RV covers for sale. Many dealers provide covers at affordable prices. Happy travels and safe adventures!
Average Rating